Create your security system with a simple infrared webcam

Create your security system with a simple infrared webcam

It may have been times when you have your security system infrared was monitored around the perimeter of your home. The problem is that the night vision cameras and lights huge dent in your pocket and can cause you chose, your plans pushed to the backburner. Well, you can bring this project to life again, because there is a convenient way to get your home security system.

You only need a simple webcam, preferably at low cost. They alsoneed some used film negatives, some high-intensity infrared LEDs that device from any electronics store for less than a dollar a power for the LED lights you need for less than ten dollars, a few boxes, polarity wires can get can get an electronic bread, and tools such as a welder.

First you need to unscrew the camera through its plastic case open. Then try the webcam, removed from the optical media. On some cameras, the assembly is screwed,while on other cameras, it's just kind of shots.

Once you have taken from the lens, you should see a small square glass to the floor. This includes the red-colored filters, infrared webcam, what stops the infrared light recorded by the sensor of the webcam. Remove the filter carefully with a knife from his pocket slowly scraping the glue from the edges and then leverage the same knife.

Replace uses the IR filter with a negative insteadblacker, you can find and cut two pieces of approximately the same size as the IR filter you have chosen. Fit the two pieces of film cut into the slot, which uses the IR filters. Carefully attach the new filter with quick-drying glue, does not care about some of the glue on the lens or camera in the release of two pieces Negative.

Set the lens back the webcam and replace the rest of the parts. Then connect the camera to the computer and see if it can also detecteach color. Next, try to eight high-intensity infrared LEDs placed on a bread board and connect it with a daisy chain. Make sure that the polarity of each LED corresponding to the other, and then leave it isolated by a thin insulating tape. Attach this assembly to a box of thick cardboard and attach it to a power supply.

Try to reconfigure the webcam, to focus the light to see if it is turned on. If all goes as planned, to connect these two components on another boardset the camera up and the lights on the bottom.

Now you have a working structure of a near infrared illuminator with a surveillance camera. The best part is, it will only cost about 40 to 50 dollars. How's that for a half hour the task?

bling dj headphones peak jump starter